Test Firing The 3D Printed Liberator

“Alright. One…two…”

Before “three” arrives, a shot reverberates across the overcast central Texas landscape. A tall, sandy blond engineer named John has just pulled a twenty-foot length of yellow string tied to a trigger, which has successfully fired the world’s first entirely 3D-printed gun for the very first time, rocketing a .380 caliber bullet into a berm of dirt and prairie brush.

“Fuckin’ A!” yells John, who has asked me not to publish his full name. He hurries over to examine the firearm bolted to an aluminum frame. But the first to get there is Cody Wilson, a square-jawed and stubbled 25 year-old in a polo shirt and baseball cap. John may have pulled the trigger, but the gun is Wilson’s brainchild. He’s spent more than a year dreaming of its creation, and dubbed it “the Liberator” in an homage to the cheap, one-shot pistols designed to be air-dropped by the Allies over France during its Nazi occupation in World War II.

Unlike the original, steel Liberator, though, Wilson’s weapon is almost entirely plastic: Fifteen of its 16 pieces have been created inside an $8,000 second-hand Stratasys Dimension SST 3D printer, a machine that lays down threads of melted polymer that add up to precisely-shaped solid objects just as easily as a traditional printer lays ink on a page. The only non-printed piece is a common hardware store nail used as its firing pin.

Wilson crouches over the gun and pulls out the barrel, which was printed over the course of four hours earlier the same morning. Despite the explosion that just occurred inside of it, both the barrel and the body of the gun seem entirely unscathed.

Wilson scrutinizes his creation for a few more seconds, then stands up again. “I think we did it,” he says, a little incredulous.

Read the rest of the article: http://www.forbes.com/sites/andygreenberg/2013/05/05/meet-the-liberator-test-firing-the-worlds-first-fully-3d-printed-gun/print/